www.racorstoragesolutions.comAssembly and installation instructionsPHL-1RCeiling Storage LiftWARNINGPlease read installation instructions carefully pr
RTools required: stud finder, wrench, cordless drill/driver, phillips screwdriver, 10 mm socket wrench, pencil, 4 ft. straightedge, and pliers.Parts li
Assemble platform Lay the three wire platforms on the floor. Place the wire platform with the four tabs in the middle. These tabs will fit into th
48" APARTAssemble and install the two arm supports Locate ceiling joists for each Arm support. Arm supports need to be secured directly to and a
Assemble and install axles and cableassemblies Slide together the Axles but do not assemble with screws yet.The bolt holes should be in line
Attach cable assemblyto platform21(Large adjustment) (Small adjustment) Thread one nut half-way up the eye-bolt at the end of the Cable assemblies
Operation The gear drive that is attached to one end of the Axle supports has a safety lock. The safety lock is designed that it can be swung out to
WARNING! Before raising or lowering the platform, clear all people and obstructions from under the platform in a 6ft x 6ft area. When loading the pl
Comentarios a estos manuales